CLUTCH DISK
The clutch disk is covered with a special lining (used to be asbestos: now it’s a fiberglass composite). The lining […]
The clutch disk is covered with a special lining (used to be asbestos: now it’s a fiberglass composite). The lining […]
Many cars have a clutch cable linkage. A cable can be run around corners and allow flexibility of car design. A
The flywheel is the other surface the clutch disc rubs on. It often must be resurfaced (turned) when the clutch
A hydraulic clutch linkage is even more flexible than a cable. A hydraulic clutch has a clutch master cylinder behind the clutch
Several types of linkage are used to connect the clutch pedal to the throwout bearing and pressure plate. These include:
The throwout or release bearing presses on pressure plate to release clutch. It should also be replaced with each clutch job.
THROWOUT / RELEASE BEARING Read Post »
The rod and bellcrank linkage has a series of rods and pivots that connect directly to the clutch. This is probably the
Rod and Bellcrank Linkage Read Post »
The pressure plate is is a spring loaded device which presses the clutch disk against the flywheel. It should be replaced with
(Some Cars) The pilot bearing or bushing supports the outer end of the transmission input shaft. It is located in the center of the
PILOT SHAFT BEARING OR BUSHING Read Post »